Elba DOMINO COOKING HOBS Informações Técnicas descarregar pdf (Página 20)

30 mm

Fig. 6.3

Space for

connections

Clearance

Cupboard

door

Fig. 6.4

WITH CUPBOARD DOORS

(fig. 6.3)

The fixture has to be made according to

specific requirements in order to prevent

the gas burners from going out, even

when the flame is turned down to mini-

mum, due to pressure changes while

opening or closing the cupboard doors.

It is recommended that a 30 mm clear-

ance be left between the cooker top and

the fixture surface beneath it.

FASTENING THE COOKTOP

(fig. 6.4)

Each cooktop is supplied with a set of

tabs and screws to fasten it on units with

a working surface from 2 to 4 cm deep.

The kit includes 4 tabs “A” and 4 self-

threading screws “B”.

✓ Cut the unit.

✓ Stretch gasket “D” over the edge of

the hole made, being careful to over-

lay the junction edges

✓ Turn the cooktop over and put tabs “A”

(fig. 6.4) into the mountings, only tight-

en screws “B” a few turns.

Make sure that the tabs are mounted

correctly as shown in the figure 6.4.

Turn the tabs so that the cooktop can

be put into the hole.

✓ Put the cooktop into the hole cut into

the unit and position it correctly.

✓ Put tabs “A”; into place, tooth “C” of

the tabs should go into the hole.

✓ Tighten screws “B” until the cooktop is

completely secured.

✓ Using a sharp tool cut off the part of

gasket “D” which protrudes from the

cooktop.

20 mm min.

40 mm max.

Fig. 6.5

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comentários a estes Manuais

Sem comentários

Elba DOMINO COOKING HOBS Informações Técnicas Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Elba DOMINO COOKING HOBS